Hydraulic oil filtration system

1, oil filter at startup, care should be taken not to pump reverse, so as to avoid blowing out oil pump shaft seal cause inhaled air. 

2, oil filter in use during the pump sucks in air, affecting oil pump, in order to achieve the rated flow oil filter and a commitment to works of fine filter elements, please check that the filter pipeline is plugged in. 

3, oil filter used for a period of time, as a result of coarse filter pollutants badly clogged due to poor surface and oil absorption (lack of oil), oil pump caused by excessive noise, please stop machine to remove oil filter cleaning or replacement filter cartridge. 

4, fine filter to use for a period of time, susceptible to pollutants gradually blocked, causing the filter drum pressure rise when pressure gauge values up to 0.4MPa, need timely replacement of fine filter. 

5, in order to guarantee the oil filter effect used oil, oil-absorbing hoses should be always kept clean.

 6, if the oil cars could not enter the oil filter, check finds that: 
A, shift transmission oil pump is correct; 
B, fuel tanks to port between the reliability of components sealed, oil suction leave oil or oil has been finished or sucker suck barrel wall; 
C, coarse filter is seriously blocked. 
D, oil pump shaft seal for damage. 

7, oil filter car traffic significantly reduces, please check finds that: 
A, coarse and fine filter filter is blocked serious; 
B, oil pump shaft oil seal wear and tear or due to long time anti-causing blowing out instead. 

8, filter pressure suddenly dropped, check the fine filter elements for breakdown damage
Lubricating oil purificationInsulating oil Purification,
 Turbine oil purificationWaste engine oil purification

Hydraulic oil recycling
Hydraulic oil is good or bad, not only affect the normal operation of construction machinery, and may damage the hydraulic system components. Filtration Equipment Manufacturing Co., Ltd. Chongqing zhongneng technician in the oil summed up thechanges in the quality of hydraulic oil identification methods:
1, pump oil identification
Remove from the oil pump a little oil under test, if it has shown its milky white turbid state(and sometimes, like yellow milk), and identification with the combustion method, and found that it contains large amounts of water, hand-feel has lost its stickiness, then the has been thoroughly emulsified oil deterioration, should not be reused.
2, identify the oil tank
Measured from the tank out of a little oil, with filter paper, if there black residue retained on the filter paper, and have a pungent odor, then the oil has been oxidized, can also beremoved from the bottom part of settling tank sludge, if found many bitumen and colloidprecipitation, place your fingers on the twist kneading, if glial feel more strong adhesion, then the oil has been oxidized.

The solution: use our TYA series devices can effectively solve the hydraulic oil emulsionoxidation deterioration and so on.

Equipment works Principle:

Oil filter work, large amount of oil through the efficient and pollutant-specific filters toremove impurities. Use a special manifold and the vacuum separator personalized, within which the use of lipophilicity technology and "cavitation" principle, the oil separator in a vacuum in the expansion of the original contact area hundreds of times, and "cavitation" system and increasing the surface area of ​​the oil evaporated, and the evaporationinterface is continuously updated to maximize the oil in the vacuum system in the area of ​​travel and the static water evaporation, the oil in the water at low heat, high vacuum, a large surface, high pumping speed under the conditions of rapid vaporization of theevaporated by the vacuum system discharge.

By the vacuum separator upper discharge of water, gas, cooling and dehumidificationsystem step by step, after cooling, and finally by the vacuum pump to the air.

Vacuum separator dehydration by vacuum evaporation after drying oil, the pump was promoted by the negative pressure, through the fine filter, the absolute oil from the oildischarge port, complete the Absolute process.

Find more oil filtration machines
Series ZY Single-Stage Vacuum Transformer Oil Purifier 
Series ZYD Double High Vacuum Transformer Oil Purifier 
Series ZYD-I Tansformer Oil Filtration and Regeneration system
Series ZYB Multiply-Function insulating oil treatment machine 
Series ZYD-PLC Transformer Oil Purifier with PLC control